Automatic voltage stabilizer 1000 VA 3%/ 800 W Qoltec AVR PRO

The Qoltec AVR PRO automatic voltage stabilizer is used for automatic regulation of mains voltage and helps protect connected electrical devices from unwanted fluctuations.

A typical use is voltage stabilization between a generator or the power grid and a device powered from a 230 V AC supply. The stabilizer automatically lowers excessively high voltage and raises low voltage to the required level.

If the voltage exceeds a safe value, the stabilizer disconnects the connected device from the mains and helps protect it from damage.

The stabilizer is suitable, for example, for servers, routers, modems, computer setups, network components, TVs, audio equipment and other compatible electronics.

Technical parameters:
Type: single-phase
Power: 1000 VA / 800 W
Transformer: servo motor
Power factor: 0.8
Output voltage: 230 V
Input voltage range AC: 220–240 V
Frequency: 50–60 Hz
Accuracy: ±10 %
Efficiency: >95 %
LCD display: yes
Optional delay time: 6 or 180 seconds
Power cable: 1× EU plug
Connectors: no
Sockets: 2× Schuko
Protection rating: IP20

Use and warnings:
Do not exceed the maximum power of the stabilizer. Devices equipped with a motor or compressor may require significantly higher power at startup than during normal operation.

Before use, make sure the input voltage is within the permitted range and the output voltage matches the requirements of the connected device.

Use the stabilizer in a well-ventilated area, away from direct sunlight, water, moisture, oils and flammable substances.

First connect the load to the stabilizer, then switch on the AVR and then the connected device.